Castle TSM-21 Serial 64234 and above (Bosch) Operator Manual User Manual
Page 29
CASTLE, INC
TSM-21 OWNERS MANUAL V2.0
Page 29 of 41
Note:
Failure to clean sawdust from your machine may void your Warranty!
Castle provides premium versions of the Router Bit and Drill Bit in the TSM-21 as standard
equipment from the factory. Castle recommends these bits for all applications:
Part No
Part Description
Function
B00338
Solid Carbide,
3
/
8
”
Rough Mill, Three
Flute Bit
Routs pocket – Works in all materials, especially particle
board, plywood, MDF, Melamine, etc.
B02964
TiN Coated,
9
/
64
”
Brad and Spur Bit
Drills pilot hole – Works well in all materials. TiN coating
provides longer life than standard bits.
B00438
Cobalt Steel,
3
/
8
”
Rough Mill, Four
Flute (RM-38)
An alternative when cutting pockets exclusively in solid woods
such as maple, oak, ash or alder. The B00038 will cut in any
material, however exposure to glue and resin found in particle
board, plywood, MDF, Melamine, etc. will lead to premature
wear on the bit.
B00964
9
/
64
” Brad and Spur
Bit w/
1
/
4
” Shank
(CDB-964)
An economic alternative based on the geometry of our
premium TiN coated pilot bit.
B01964
9
/
64
” Split Point Bit w/
1
/
4
” Shank
An alternative to the B00964. The split point construction is
stiffer and is preferred in plywood and tightly grained hard
woods.
B00764
7
/
64
” Split Point Bit w/
1
/
4
” Shank
An alternative for smaller diameter pilot hole
B00316
3
/
16
” Split Point Bit w/
1
/
4
” Shank
An alternative for larger diameter pilot hole
To purchase bits feel free to contact your local Castle dealer or contact our Parts Department
TOLL FREE at 800-282-8338 or visit our website at www.castleusa.com for information and
pricing on tooling and accessory products for your TSM-21.