Castle LB-23 Diagnostics Manual User Manual

Page 14

Advertising
background image

Revised 2/9/2007

2. Use a piece of board to cut a full row of holes in. Make sure that there isn't much sawdust
remaining in the holes.

3. Slide the board over so that the Index Pin will enter the last hole, but still leave the majority of
holes underneath the head.

4. Bring the head down into the previous holes while watching very closely that the bits are entering
in the exact center.

5. While the head is down place the Index Pin into the hole (if not already there), and tighten the nuts
on the bracket.







































Advertising