Castle LB-23 Diagnostics Manual - Manual (Page 3)

3. Add 10 to 15 drops of oil to each of the holes. The oil is picked up by the wick and distributed
evenly among the spindles
4. Locate the Drive Link Pins and add 1 or 2 drops of oil to each. The pins can be oiled once every
30 hours of usage. However, this should only be done if the head is in good adjustment, but still has a
metallic rattle.
5. After the oil is added the machine should be left running for AT LEAST 30 minutes and then all
excess oil wiped off. If the clean up of the oil is not thorough enough, the machine will throw oil on
the stock.
Revised 2/9/2007