Climax FF6000 PORTABLE FLANGE FACER - Manual

B r i n g i n g t h e s o l u t i o n t o y o u .
Portable Machine Tools, Inc.
®
F E A T U R E S • S E T U P & O P E R A T I O N
C O M P O N E N T S & A C C E S S O R I E S • T E C H N I C A L D A T A
FF6000 PORTABLE FLANGE FACER
Cut your dismantling & downtime costs by re-facing flanges and
repairing seal & bearing fits at the work site
This flange facer will substantially
reduce your costs and maintenance
downtime by allowing you to quickly
repair your flanges, seals, and bearing
fits in place without resorting to costly
disassembly and transportation to a
machine shop. This versatile on-site
flange facing machine will also help
to eliminate expensive and time-
consuming recertification procedures
which may be required when critical
valves and flanges are removed for
repair and then re-installed. The job
can be done quickly to get back in
operation with minimum downtime.
An experienced operator can usually
mount the machine in the flange
bore, align it, and start cutting in 30
minutes.
Solid
Single plane chuck provides rigid •
clamping in the bore.
3 inch (76 mm) diameter turning •
bar ensures a rigid tool platform,
even at maximum extension.
A combination of precision ball •
bearings and heavy-duty Timken
Tapered roller bearings for smooth,
chatter-free machining
Effective
• 9.73:1 gear reduction provides 550
ft•lbs (798 N•m) of torque at the
cutter to remove metal fast.
• Radial feed is 0.003 - 0.032 inch
(0.076 - 0.813 mm) per revolution,
infinitely variable, reversible, rack and
pinion system.
• Down feed rates from 0.003 - 0.010
inch (0.076 - 0.0254 mm) per
revolution are provided by the down-
feed actuator system.
• Tool holder accepts 1/2 inch or 12
mm square tool bits.
Versatile
Sealed lubrication allows inverted •
operation.
Standard tool head swivels 360 •
degrees in either direction to cut
angles, grooves, chamfers, RTJ, and
weld preps. Use the optional Low
Angle tool holder to cut angles less
t han 45 degrees to the flange face.
Down-feed allows turning flange •
edges, and dressing inside flange/
pipe joints,
Optional large bore chuck and •
bar assembly for flanges up to 60
inches (1524 mm) in diameter.
Other options include: •
- Grinding attachment
- Back facing attachment
- Low-angle tool holder