CEMB USA C211 (C) - Manual (Page 9)

I 0147 - 8 I 0147 - 9
10
10a
10b
10c
GB GB
a
d
b
Reading
6.2 - Manual presetting
The dimensions can be entered or modified in manual mode by proceeding as follows:
6.2.1 - Standard wheels
- DISTANCE: preset distance “a” of the wheel inside
from the machine after measuring it with relative gauge.
Increment pitch 0.5 cm
Full scale 40 cm
- DIAMETER: preset nominal diameter “d” marked
on the tyre.
Increment pitches:
- unit of measurement in mm = 12/13 mm
- unit of measurement in inches = 0.5”
- WIDTH: preset the nominal width stamped
on the rim or else measure dimension “b” of
fig. 10 with the calliper gauge (standard accessory).
Increment pitches:
- unit of measurement in mm = 5 mm
- unit of measurement in inches = 0.25”
( .2 is displayed for 1/4”; .5 for 1/2”; 7 for 3/4” )