CEMB USA C73 (A) - Manual (Page 10)

I 0567 - 10
8
8a
Pos B
Pos A
FI
GB
5.3 - Presetting of wheel dimensions
5.3.1 - Automatic presetting (see also
CORRECTION MODE
)
►
►
5.3.1.1 - Standard wheels
The screen appears upon removing the distance + diameter gauge.
The “dimension acquired” message is indicated by the correction weight symbol, which changes from blue to red.
- INNER SIDE WEIGHT: Using the special grip, move the end of the gauge against the rim in position:
a) Sprung weight : in one of the positions A/B indicated in fi gure 8.
►
INDICATOR
L.T. function enabled
(see Buttons
Enabled)
INDICATOR: Width
Sonar function
enabled
b) Adhesive weight: in the position indicated below
Note: Always use the round part of the striker plate.
Position of adhesive
weight
Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (see
ACOUSTIC SIGNAL ), the acquisition of the dimensions is accompanied by a
“beep”.