CEMB USA C73 (A) - Manual (Page 24)

I 0567 - 24 GB
6 - SETUP (see Diagram showing access to the menus)
The Setup screen provides the user with many possibilities required for presetting the machine according to his own
requirements. Such settings remain unaltered even when the machine is switched off.
The following buttons are enabled:
: return to previous window
: return to Measurement screen
from to : for selection of the parameter.
6. ► 1 - Language
This function allows selecting the language to be used for displaying descriptive and diagnostic messages regarding
machine operation.
6.2 - Unit of unbalance measurement ►
It is possible to select whether to display the unbalance values expressed in grams or ounces.
6.3 - Unbalance display threshold ►
This consists of the unbalance threshold below which the wording “-OK-” appears on the screen at the end of the spin
instead of the unbalance; the presettable values vary according to the unit of measurement selected.
6.4 - Unbalance display pitch ►
This represents the display pitch of the unbalance and varies according to the unit of measurement selected. The selection
“5 g” (1/4 oz) enables display of the correction values on both sides such as to bring the static unbalance to 0 (theoreti-
cal). It is recommended to preset this function as standard use of the machine as it improves the balancing quality. The
computer makes a complex calculation which allows cancelling the residual static unbalance by varying the value and
position of the counterweights fi xed in steps of 5 grams (1/4 oz).
6.5 - Spin with guard closed ►
When “ON” is selected the automatic start of the spin is enabled when the guard is closed.
6.6 - Screen-saver time ►
If this function is enabled, the screensaver will automatically be activated when the machine is not used for a certain
period of time. This function can be disabled by setting it to 0
6.7 - Visual eccentricity check ►
At the end of wheel acceleration, as soon as the motor is disengaged, the guard can be opened for visual control of
any wheel eccentricity as the rotation speed gradually drops.
Do not strike the wheel during the entire deceleration stage; to brake the wheel, close the guard. However, avoid using
the brake as far as possible because this may compromise unbalance measurements. The unbalance values measu-
red are only displayed when the wheel has come to a standstill. This function is active for only one machine run.
6 ► .8 - Acoustic signal
When “ON” is selected, the sending of an acoustic signal (beep) is enabled in the following cases:
- when any push button is pressed;
- when dimensions are acquired in automatic mode;
- when the correct angular position for weight application is reached in the Measurement screen;
- when the correct angular position for weight application is reached in the Position Repeater screen.