Activate/deactivate defect pixel correction, Store defect pixel data non-volatile, Load non-volatile stored defect pixel data – ALLIED Vision Technologies Guppy PRO F-503 User Manual
Page 118: Send defect pixel data to the host, Receive defect pixel data from the host
Description of the data path
Guppy PRO Technical Manual V4.0.0
116
9.
Grab a single image (one-shot).
Activate/deactivate defect pixel correction
Activate:
1.
Set ON_OFF flag to 1.
Deactivate:
1.
Set ON_OFF flag to 0.
Store defect pixel data non-volatile
1.
Set the MemSave flag to 1.
Load non-volatile stored defect pixel data
1.
Set the MemLoad flag to 1.
All non-volatile stored defect pixel coordinates are loaded.
Send defect pixel data to the host
1.
Set EnaMemRD flag to 1.
Defect pixel data is transferred from dual port RAM to host.
2.
Read DPDataSize.
This is the current defect pixel count from the camera.
Receive defect pixel data from the host
1.
Set EnaMemWR flag to 1.
Note
•
Switch off camera and switch on again:
defect pixel data will get lost
•
Initialize camera (start-up or soft reset):
non-volatile stored defect pixel data are loaded
automatically