ALLIED Vision Technologies Manta G-917 - Manual (Page 113)

Manta Technical Manual V7.0.1
113
Camera interfaces
Control signals
The inputs and outputs of the camera can be configured by software. The differ-
ent modes are described below.
Inputs
Input/output pin control
All input and output signals running over the camera I/O connector are con-
trolled by the I/O strobe commands. See
AVT GigE Camera and Driver Features
for more details.
Outputs
Output features are configured by software. Any signal can be placed on any
output. The main features of output signals are described below:
Note

For a general description of the outputs and
warnings see the
AVT GigE Installation Manual .
Figure 73: Input block diagram
Note

For a general description of the outputs and
warnings see the
AVT GigE Installation Manual .
Polarity
selectable
via software
Input state
Input signal
Optocoupler
LP filter