ALLIED Vision Technologies Manta G-917 - Manual (Page 46)

Manta Technical Manual V7.0.1
46
Specifications
Manta G-282B/C
Feature Specification
Sensor Type 1/1.8 (diag. 8.9 mm) progressive scan SONY IT CCD ICX687ALA/AQA
with EXview HAD II microlenses
Effective chip size 7.14 mm x 5.38 mm
Cell size 3.69 μm x 3.69 μm
Resolution (maximum) 1936 x 1458 pixels
Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 9.7 mm (see
figure 64 on page 102)
ADC 14 bit
Pixel format Only monochrome: Mono8, Mono12Packed, Mono12
Only color: BayerRG8, BayerRG12Packed, BayerRG12, Mono8,
RGB8Packed, YUV411Packed, YUV422Packed, YUV444Packed,
BGR8Packed
Frame rates Up to 30 fps
Gain control Manual: 0–32 dB (1 dB/step); auto gain (select. ROI)
Exposure time 41 μs to 60 s; auto shutter (select. ROI)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 60 seconds in 1 μs increments
Fixed rate control 1 fps to maximum frame rate (steps of 0.1 fps)
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO
Internal image memory 128 MByte, up to 47 frames
Smart functions Auto gain control, auto exposure control, binning (monochrome bin-
ning, also for color cameras; but no color binning), decimation (sub-
sampling), config files (user sets); LUT, temperature monitoring (resolu-
tion 0.031, accuracy ±1°C)
only color: auto white balance, color correction, hue, saturation
I/O Two configurable optocoupled inputs, two configurable optocoupled
outputs
RS232 port (serial port)
Digital interface IEEE 802.3 1000BASE-T (GigE Vision V1.2)
Camera control interface GenICam V1.0 compliant
Table 14: Specification Manta G-282B/C
Note

The number of frames (StreamHoldCapacity) depends on resolu-
tion and pixel format. Listed number of frames is typical for full
resolution and Mono8/Bayer8.