Camera i/o connector pin assignment – ALLIED Vision Technologies Prosilica GC2450 User Manual
Page 50
Prosilica GC Technical Manual V2.0.8
50
Camera interfaces
Camera I/O connector pin assignment
The general purpose I/O port uses a Hirose HR10A-10R-12PB connector on the
camera side. The mating cable connector is Hirose HR10A-10P-12S.
Figure 35: Camera I/O connector pin assignment
Note
The cable side Hirose connector is available for
purchase from AVT.
AVT P/N: K7600040 or 02-7002A
Pin Signal
Direction Level
Description
1
Camera GND
In
GND for ext. power Ground for camera power
supply
2
Camera Power In
5–16* VDC
Camera power supply
3
In 1
In
U
in
(high) = 5–24 V
U
in
(low) = 0–0.8 V
Input 1 opto-isolated
(SyncIn1)
4
Out 1
Out
Open emitter max.
20 mA
Output 1 opto-isolated
(SyncOut1)
5
Isolated IO
GND
In/Out
Common GND for
In/Out
Isolated input and output
signal ground
6
Video iris
Out
---
PWM signal for iris control
7
Reserved
---
---
---
8
TxD RS-232
Out
RS-232
Terminal transmit data
9
RxD RS-232
In
RS-232
Terminal receive data
10 Signal GND
---
---
Ground for RS232 and non-
isolated IO
11 In 2
In
LVTTL max. 3.3 V
Input 2 non-isolated (SyncIn2)
12 Out 2
Out
LVTTL max. 3.3 V
Output 2 non-isolated
(SyncOut2)
*Some models offer 5-25 VDC. See
section for details.
1
9
8
7
6
5
4
3
2
11 12
10