Auto Page C3-RS1100 - Manual (Page 14)

C3 RS1100REV. A 14
This wire provides a 200mA (-) ground output that becomes active 4 seconds before
the remote start unit initialize, and remains grounded while running.
Ignition 3 output:
Some newer vehicles use a third
ignition wire which is required to start
and keep the vehicle’s engine
running. If this is the case, wire an
IGN 3 relay (not supplied) as shown
below: Do not connect any vehicle
circuits together, they are isolated for
a reason.
Yellow Wire
87a
Ignition 3 Wire From
Ignition Key Switch
+ 12 V Constant
Fused 25A Capable
30
85 86
87
Transponder interfacing using relay:
If the vehicle has a transponder system installed, you will need to by-pass the system
while the vehicle is
operating under the control of the Remote Start Unit.
To do this:
1.You will need a transponder key that's already programmed to the vehicle.
2.Remove the trim around the ignition switch.
3.Wrap a thin (28 - 30awg) wire tightly around ignition switch 6 to 8 times and secure it.
4.About 6"down line make another loop of approximately 2"diameter.
5.Place the key inside this l oop and secure it to the loop.
6. Connect on end of the (28 - 30awg) wire to pin (87) of the relay module.
7. Connect the other end of the loop wire to Pin (30) of relay module.
8. Connect the pin (86) of the relay module to the ignition wire from the ignition switch.
9. Connect the pin (85) of the relay module to the H10/11 yellow wire of 20-pin
connector.
GM VATS KEY OVERRIDE:
If the vehicle has the General Motor VATS system installed, you will need to by-pass
the system while the vehicle is operating under the control of the Remote Start Unit.
To do this:
1. Measure the resistance of the resistor pellet on the ignition key then select a
resistor within 5% of the key’s value.
2. Locate the pair of VATS wires in the vehicle, usually a pair of thin gauge wires
running from the ignition switch to the VATS control module.
3. Connect the YELLOW wire from Remote Start Unit to TERMINAL #85 of an
external relay. Connect terminal #86 of the relay to a fused +12 volt.
4. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to
terminal #87a of the relay. Connect the other side of the (#1) wire to terminal #30.
5. Connect the previously seleted resistor from terminal #87 to the second(#2) wire
(as shown).