Auto Page C3-RS1100 - Manual (Page 24)

C3 RS1100REV. A 24
Program:
1. Press and release the transmitter button twice, [2] LED flash, [2] siren/horn
chirp to indicate you are in features “Password pin code programming mode”.
2. Within 5 seconds, press and release the valet Switch 9 times.
3. Within 15 seconds of the last entered 9ths digit, turn the Ignition Switch to “ON”
position.
4. Within 15 seconds press the valet Switch twice.
5. Turn the Ignition Switch to “OFF’ position.
You will note the LED flashing nine times, pause and then flash two times, pause.
This pattern will be repeated three times indicating the new code (92) has been
accepted and stored in memory.
Exit: Press any button (except button) of the transmitter to exit the password pin set
up mode.
REMOTE START FEATURE PROGRAM MODE.
START FEATURE “D” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 9 times (holding in on the 9
th
push) until four chirps with one
long chirp is heard then release the valet switch. You are now in the Sta rt feature
“D” programming mode.
3. Press and release the transmitter button corresponding to the feature you want to
program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
+
Gasoline Engine
Diesel Engine
with
Wait-To-Start
Light (H6/13
White/Green
wire must be
connected)
Diesel Engine
without
Wait-To-Start
Light
10 seconds
warm -up timer
Diesel Engine
without
Wait-To-Start
Light
15 seconds
warm-up timer
Diesel Engine
without
Wait-To-Start
Light
20 seconds
warm-up timer
2
Factory alarm
disarm with
channel 3 on
Without this
feature
3
Constant parking
light output upon
Remote Start
Flashing parking
light output upon
Remote Start
4
20 minutes run
time
30 minutes run
time
10 minutes run
time
5 minutes run
time
5
Door lock before
start
Door lock after
shut-down
Door lock before
start and Door
lock after
shut-down
Without this
feature