Auto Page C3-RS1100 - Manual (Page 21)

C3 RS1100REV. A 21
(The system Can not
be Arm with the
engine running)
The shock sensor
will be
by-passed upon
engine running.
(The engine will
run by itself after
the ignition is
turned off)
The shock sensor
by-pass three
minutes after
armed.
(The engine will
run by itself after
the ignition is
turned off)
Press and
buttons at
the same time
to control
Engine run time
for one minute
and the shock
sensor will be
by-passed upon
engine running.
Five chirps = Press and buttons at the same time
to control Engine run time for three minutes and the shock
sensor will be by-pass upon engine running.
Six chirps = Press and buttons at the same time
to control Engine run time for five minutes and the shock
sensor will be by-passed upon engine running.
7 +
Enable the out of
range check Disable the out of
range check.
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking
light flashes will confirm exit.
Comfort Feature:
Some Vehicles have a special “COMFORT feature”. When you lock the door with the
key, you can keep turning the key in the door for about 5 to 7 seconds and the window
will close directly. If your vehicle has the “COMFORT feature” and you wish for the door
to be locked and the window to be closed automatically at the same time by remote
control, you can set the alarm feature “ B-3 “with comfort feature”.
ALARM FEATURE “C” PRORAMMING:
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay i n OFF position.
2 Push the Valet switch 7 times (holding in on the 7th push) until three chirps with
one long chirp is heard then release the valet switch. You are now in the Alarm
feature “C” programming mode.
3 Press and release the transmitter button corresponding to the feature you want to
program.
Press
Transmitter
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps / LED
two pulses
Three Chirps /
LED three pulses
Four Chirps / LED
four pulses
1
H6/3 Pink Wire =
Two step door
unlock output
H6/3 Pink Wire =
Factory Security
Disarm Signal
Output
H6/3 Pink Wire =
Start Status
Output
(Shock Sensor
Bypass)
H6/3 Pink Wire =
Start Status Output
(Shock Sensor
Bypass 20 SEC)