DE DIETRICH TWINEO EGC 25 - Manual (Page 20)

1. Press the r key 1 times.
2. The symbol r and the current temperature are displayed (the
temperature flashes, e.g. 60°C).
3. Change the value by pressing the [-] or [+] key. In this example
using key [-] to 55°C.
4. To confirm, press the S key.
4.3.6. Modifying the domestic hot water set point
temperature
To modify the set point of the solar tank (if connected), proceed as
follows
1. Press the r key for 3 seconds.
2. Symbols r and S; and the current temperature are displayed
(for example, S; and the temperature 60°C flash).
3. Change the value by pressing the [-] or [+] key. In this example
using key [-] to 55°C.
4. To confirm, press the S key.
4.4 Installation shutdown
CAUTION
Do not switch off the boiler.
If the central heating system is not used for a long period, we
recommend proceeeding as follows:
4
Press key d until OFF is displayed.
4
Press key r until OFF is displayed.
4.5 Antifreeze protection
When the heating water temperature in the boiler is too low, the
integrated boiler protection system starts up. This protection functions
as follows:
4
If the water temperature is lower than 7°C, the heating pump starts
up.
4
If the water temperature is lower than 4°C, the boiler starts up.
4
If the water temperature is higher than 10°C, the boiler shuts down
and the circulation pump continues to run for a short time.
4
If the water temperature in the storage tank is less than 4°C, it is
reheated to its set point.
C003053-A
1x
C003912-A
1x
1x
4. Operating the appliance EGC 25
19 03/12/2013 - 300026082-001-02