eLine Technology ECO3 User Manual - Manual (Page 13)

13
Net DVR
● Don’t touch the power switch or the Net DVR by wet hands.
● Make sure the machine and its case are grounded (There is an earth interface on the back panel of t he machine).
● Keep the power supplier stable to avoid abnormal power cutoff.
● Avoid dropping liquid or metal into machine that may cause short circuit or fire.
● Don’t record or playback until at least one HDD is installed.
● Short circuit would happen when moist dust is on the board , so user has to termly brush the board and other accessories to make the machine
work in good condition.
● Video/audio/RS485 devices cann’t be plug or draw when the power is on, or else the equipment will be easily damaged.
● Use the power on/off button on the front panel instead of direct shut off the power directly when turn off the Net DVR, so that the hard disk
won’t be damaged.
● DVR can scan the entered HDD automatically,if the HDD is the new one that is not formatted by DVR, t he system will prompt users to
format. (system can support formatting, it will not depends on PC).
● Warning: Please don't try to connect the DVR HDD to PC if you are not professional person;The illea gal operations such as revise or
edit the file name, open the file and edit, copy back the recording data that was copied out before etc; and some third party browsing software
can modify the physics store location of files in the HDD at the backstage;above operations will be lead to HDD record data cannot be
identificated and request formatting when connect the HDD.
● When hot swap the SATA hard disk, please plug in/out the data cable and power cable together.
● In order to keep the integrality of the records, damaged disks should be exchanged promptly. (There is information about the error of the
disk in the logbook.)
Cautions: