eLine Technology ECO3 User Manual - Manual (Page 43)

43
Net DVR
(3) Choose the sensor type.
(4) Choose the sensor number.
(5) Set the deployment period (the specific setting please refer to schedule record),left click mouse to set start point then drag mouse to the end point.
(6) The linkage record channel can record when alarming, we recommend that each channel correspond with each sensor, so that we can find the
alarm record files by channel, the yellow channel button means have linkage alarm record, gray means not linkage to any alarm record.
(7) Alarm output setup: you can select the alarm output button. (Yellow indicates enable, and grey indicates disable).
The system support recall to preset point function when alarm appear(the precondition is the cam era support preset function),the setting procedure
is as follows:
1.Click “PTZ preset point” to enter the PTZ preset interface, then you
can set the preset point.(Note: the range of the PTZ preset is 1-255,255
means close, when copying the channel parameters, these settings will not
copied to other channels). After finishing this operation, you should right
click mouse to enter the up menu and click “save” to activate the setting.
2.In “COM Setup” interface you can set COM type, COM device, baudrate.
In the PTZ setup interface you can set the protocol, address code.
3.Switch to the channel which you want to set preset points, press the
“PTZ” button on remote controller to enter the PTZ control mode, then
press “PRESET”, input the preset number mentioned in step 1,or you can
right click the mouse to enter the PTZ status, select “PTZ”, then you can
see the interface, input the preset number mentioned in step 1 to the box,
click “preset” to save setting. Right click the mouse again to quit.