eLine Technology ECO3 User Manual - Manual (Page 47)

47
Net DVR
4.6.2 PTZ
The procedure of PTZ setting:
 Set COM type, COM device and baudrate in the “COM setup” interface.
 Enter the “PTZ Setup” interface to set protocol and address code (The default PTZ address code is co incide with every channel, for instance, the
first channel’s PTZ address code is 1).
Note: PTZ protocol, baudrate, address code must coincide with the PTZ camera itself.
 Switch the channel to single picture display status, press the “PTZ” key on the remote controller to get in the PTZ control mode, then you can use
the remote controller to control the PTZ, press “PTZ” again you can quit the PTZ control mode; You can also right click the mouse to enter the PTZ
control interface.
 Setting and calling preset point by the remote controller :
Enter the PTZ status, press the direction button make the PTZ turn the
direction which you want to set as preset point,press “*preset” botton
on remote controller and input the No. of the preset point in the box(such
as 001),then turn the PTZ to another direction,if you press the
“#call” button and input the No. (1) which you preset to the box,the
PTZ will turn to the 001 preset point automatically.
 Setting and calling preset point by mouse: Enter the PTZ status, double
left click mouse at the preset input box to enable the software-keyboard
and input the preset No.(such as 1).Right click mouse to quit software-
keyboard, then click “preset” to activate the setup. Then turn the PTZ to
another direction,if you click the “call” and input the No.(1) which you
preset to the box,the PTZ will turn to the 1 preset point automatically.
Click “return” to quit the PTZ interface.