Hydrotech 7000 Service Manual - Manual (Page 28)

Model 7000
28
Connecting Circuit Board
After the circuit board is installed:
1. Connect the motor wires (A) to the motor connector (A1) on board.
2. Connect the transformer cable (B) to the transformer connector (B1) on board.
3. Connect the meter cable (C) to the meter cable connector (C1) on board.
4. Connect the valve end to the opening on the valve body.
5. Thread meter cable (D1) and power wire (D2) along path shown in Figure 29 .
Figure 29: Connecting the Circuit Board
41033-2
DF254-0
41033-2
DF254-0