Hydrotech Precision-PWS 45-75 OWNERS GUIDE - Manual (Page 3)

4. IMPORTANT SAFETY PRECAUTIONS
When using electrical appliances, basic safety precautions should always be followed including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against electrical shock do not immerse cords or plugs in water or other liquid.
4. Close supervision is necessary when any appliance is used near children.
5. Do not allow children to operate this appliance.
6. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.
7. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in
any manner. Return appliance to the nearest authorized service facility for examination, repair or adjustment.
8. The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or touch hot surfaces.
11. Do not place on or near a hot gas or electric burner, or in a heated oven.
12. Extreme caution must be used when moving an appliance containing hot water.
13. Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any controls to “off”,
then remove plug from wall outlet.
14. This appliance is intended for household use.
15. Save these instructions.
5. ASSEMBLY INSTRUCTIONS
Unpacking your PWS Distiller you will find the following;
1 - Distiller Head
1 - Storage Tank
1 - Owner's Guide
1 - 24” Steam Tower - Insulated
4’ - 1 ¼” x 1 ½” Drain Tube
1 - Parts Bag Consisting of:
16' - ¼" Feed Line
1 - 1 ¼” Gear Clamp
1 - Boiling Tank Lid Assembly
1 - Storage Tank Lid Assembly
1 - 1 ¼” Ball Valve
1 - Drain Line Elbow with Coupler
1 - Sterilization Drip Tube 48”
1 - Saddle Valve
2 - Clamping Rings For Tower, w/O-Ring & Centering Ring
1 - Parts Bag Consisting of:
1 - Charcoal Jar Sample
1 - Charcoal Filter Canister Stainless Steel
1 - Sample Descaler Cleaner
1 - John Guest Removal Tool
Remove all pieces from the box and save all packaging until all parts are identified and located. Check inside boiler tank and storage
tank for any parts shipped in that area. Remove all protective plastic from distiller head, storage tank and lids.
A. SET UP
Your distiller is factory assembled and tested. You only need to assemble a few components that cannot be shipped installed on the
distiller. You will need to disconnect the electrical cord that connects your storage tank to the distiller head by unscrewing the
connection counter clockwise. Remove the distiller head from the storage tank.
1. Setting up the Storage Tank: The 75 gallon storage tank is ready for use, all of the parts are assembled on this unit. The storage
tank is cleaned and rinsed at the factory. However, you may want to rinse the tank out with pure distilled water to ensure that it is
clean. If you have ordered the pump option, see your pump assembly instructions at this time. You will find three ½” drain outlets
on the bottom of this tank. One can be used for a drain and the other two are used for the pump options.
04/08/04 Page 3 '097045