Hydrotech Precision-PWS 45-75 OWNERS GUIDE - Manual (Page 4)

2. With the head removed from the tank install the 1 ¼” ball valve, 45º elbow and barb. Use Teflon tape to get a good seal. It is also
advised that you use a back up wrench when you tighten these fittings. Figure #1.
Figure 1
3. Re-install the distiller head on the tank and hook up the electrical connectors from the tank to the back of the distiller head. Then
hook up the water feed connector to the distiller and attach the saddle valve to the water line. See Figure #2.
Figure 2
04/08/04 Page 4 '097045