Hach-Lange FP 360 sc User Manual - Manual (Page 17)

17
Section 4 Operation
4.1 User interface and navigation
The sensor can be used with sc controllers from sc100. Refer to the controller
documentation for keypad description and navigation information.
4.2 Sensor setup
When the sensor is connected for the first time, the sensor serial number is displayed as
the name of the sensor. To change the sensor name:
1. Open the MAIN MENU.
2. Select SENSOR SETUP and confirm.
3. Select the corresponding sensor and confirm.
4. Select CONFIGURE and confirm.
5. Select EDIT NAME and confirm.
6. Edit the name and confirm to return to the SENSOR SETUP menu.
Complete sensor configuration in the same manner, with the following menu options
selected:
• SET PARAMETER
• SELECT UNITS
• AVERAGE
• LOG SETUP
• GAIN VALUE
4.3 Sensor data logger
There is a data log and event log available for each sensor. 
In the data log, the measurement data are stored at preset intervals; the event log stores
events such as configuration changes, alarm messages and warning messages. Both logs
can be exported to CSV format (refer to the controller manual).