Hach-Lange FP 360 sc User Manual - Manual (Page 9)

9
General information
2.4.1 FP 360 sc sensor
Figure 2 FP 360 sc sensor
1 FP 360 sc measurement sensor 5 6 mm fitting for cleaning unit (depending on model)
2 Basic user manual with CD 6 Safety sleeve
3 Measurement window 7 Connector cable
4 Sensor with cleaning unit (depending on model) 8 Shackle
2.5 Function test
After the components are removed from the package, do a function test.
1. Connect the connector cable to the sensor (8-pin polarized connector) and an
appropriate sc controller (5-pin polarized connector) (refer to section 3.1 on page 11 ).
2. Apply power to the sc controller. The display is activated and the sensor goes to
measurement mode. 
The sensor ticks quietly and regularly.
C A U T I O N
Before power is applied, refer to the controller operation instructions.