Hach-Lange DR2800 eco - Manual (Page 24)

24
Standard Operations
5.2.5.2 Print data
1. Press Recall Data in the Main Menu.
2. Select the data source, where the data to be printed are stored.
3. A list is displayed. Data can be filtered. For more information
see section 5.3.1.2 on page 27 .
4. Press the PC & Printer icon to send the data (table, curve)
immediately to the printer.
5. Highlight Single point or Filtered data or All data and press
OK to confirm.
Sending Data... is displayed until the data have been printed.
5.2.5.3 HACH Data Trans
The optional HACH Data Trans software must be installed on the
PC for the subsequent to process for measurement data.
1. Press PC & Printer in the Instrument Setup.
2. Select PC.
3. Press Setup to display the PC Setup screen.
For further installation instructions, refer to the HACH Data
Trans user manual.
4. Select Auto-Send: On to send all measured data automatically
to the PC.
Note: If Auto-Send: Off is selected, the PC & Printer icon must be
pressed, in order to send data to the PC.
Note: The remote function is only for monitoring the data transfer.