Section 3 installation – Hach-Lange 1720E Low Range Turbidimeter User Manual
Page 13
Advertising
9
Section 3
Installation
DANGER
Only qualified personnel should conduct the tasks described in this section of the
manual. The 1720E/sc100 product configuration is not intended for installation in
hazardous locations.
3.1 Connecting/Wiring the Sensor to the sc100 Controller
3.1.1 Attaching a sc Sensor with a Quick-connect Fitting
The sensor cable is supplied with a keyed quick-connect fitting for easy attachment to the
controller, see
. Retain the connector cap to seal the connector opening in case
the sensor must be removed. The 1720E sensor cable may be extended by a maximum of
7.62 m (25 ft), see
Replacement Parts and Accessories on page 33
.
Figure 2
Attaching the Sensor using the Quick-connect Fitting
Advertising