INSTEON Energy Display (2448A2) Manual - Manual (Page 10)

Energy Display Owner’s Manual
Page 10 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
ADVANCED FEATURES OF ENERGY DISPLAY
Restoring Power to Energy Display
Energy Display stores all of its settings, such as Links to other INSTEON devices, with non-volatile memory.
Because settings are saved in this non-volatile memory, they will not be lost in the event of a power failure.
Resetting Energy Display to its Factory Default Settings
The factory reset procedure can be used to clear the Energy Display memory and restore its factory default
settings. This procedure will clear Energy Display of all INSTEON Links and Settings Mode changes. Note: this
procedure does not reset any INSTEON meter devices linked to Energy Display.
1) If you are using Energy Display to retrieve power consumption from an INSTEON device, Unlink those
devices from Energy Display. See Unlinking an INSTEON Meter Device from Energy Display .
2) Remove the battery compartment cover on the back of Energy Display
3) Remove one battery from Energy Display for at least 10 seconds
The Energy Display screen will turn off
4) While holding down the Set button, reinsert the battery into Energy Display, making sure not to let go of the
Set button
The Energy Display screen will turn on and all LCD segments will turn on
5) Continue to hold the Set button until the Energy Display screen goes blank (10 seconds) and then release
Once you release the Set button, Energy Display will beep
After a few more seconds, Energy Display will beep again and after a few flashes of the display, its
screen will be in Display Mode
6) Replace the battery compartment cover
ADDITIONAL RESOURCES
Find home automation solutions, helpful tips, interactive demos, videos, user forums, and more at the
Smarthome Learning Center:
www.smarthome.com/learningcenter.html