INSTEON Energy Display (2448A2) Manual - Manual (Page 6)

Energy Display Owner’s Manual
Page 6 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
Button Action
Mode/Setup
• Tap to cycle between display setting options:
• Instantaneous Watts used (Now | W)
• Average cost per month (Avg | $/mo)
• Average energy used per month (Avg | kWh/mo)
• Press & hold until the cost setting field begins blinking to enter Setup Mode. See
Setup Modes .
Restart/Up
Press & hold for 10 seconds to reset the energy value for the currently displayed meter
(for calculating average energy used and cost/month)
1-2-3/Down
Tap to cycle between each meter device to be displayed (Meter 1, 2, or 3)
The Energy Display will display information about your meter device after a few
seconds.
Refresh/OK
Tap to read current information for all meter devices
Set button
Press & hold for 3 seconds to Link a meter device to the current meter position on
Energy Display (Meter 1, 2, or 3). See
Linking Energy Display to an INSTEON Meter
Device .