INSTEON Energy Display (2448A2) Manual - Manual (Page 4)

Energy Display Owner’s Manual
Page 4 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
INSTALLATION
Installing Energy Display
NOTE: Energy Display uses 2 AAA batteries which will provide approximately one year of use.
1) Be sure you have properly installed at least one dual-band INSTEON device and an INSTEON meter
device (such as iMeter Solo #2423A1)
2) Remove the battery compartment door from the rear of Energy Display
3) Observe the polarity markings, install two AAA batteries, and then replace the battery compartment
door
The Energy Display screen will turn on and all the LCD segments will turn on
After a few seconds, the screen will go to Display Mode
Energy Display is now ready to use. See Linking Energy Display to an INSTEON Meter Device to begin
receiving energy information about your appliances.
HOW TO SET UP ENERGY DISPLAY TO MONITOR AN APPLIANCE’S
POWER CONSUMPTION
Linking Energy Display to an INSTEON Meter Device
Follow these steps to Link Energy Display to an INSTEON meter device (e.g., iMeter Solo). See the meter
device’s Owner’s Manual for detailed instructions on how to properly install and Link it to Energy Display.
The following will work for the most common INSTEON devices:
1) Make sure the meter device is properly installed with the appliance you wish to monitor
2) Tap the 1-2-3/Down button until the desired meter position is blinking (Meter 1, 2, or 3)
3) Set Energy Display to Linking Mode by pressing & holding the Set button until it beeps (3 seconds)
The Energy Display Status LED will begin blinking GREEN
You will have 4 minutes to complete the next step before Linking Mode automatically times out.
4) On the meter device, press & hold the Set button until it beeps (3 seconds)
Energy Display will double-beep and its Status LED will turn off.
A few moments later the Energy Display screen will display information for the meter device you
are metering
Unlinking an INSTEON Meter Device from Energy Display
If you are no longer going to use an INSTEON meter device, it is very important that you Unlink it.
Otherwise, Energy Display will retry gathering information from the unused meter device, thus slowing
down the system and reducing battery life.
The following will work on the most common INSTEON devices:
1) Use the 1-2-3,Down button to select the meter device you wish to Unlink
2) Set Energy Display to Linking Mode by pressing & holding the Set button until it beeps (3 seconds)
The Energy Display Status LED will begin blinking GREEN
3) Set Energy Display to Unlinking Mode by pressing & holding the Set button until it beeps again (3
seconds)