INSTEON Energy Display (2448A2) Manual - Manual (Page 5)

Energy Display Owner’s Manual
Page 5 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
The Energy Display Status LED will begin blinking red
You will have 4 minutes to complete the next step before Unlinking Mode automatically times out.
4) Press & hold the meter device’s Set button until it beeps (3 seconds)
Energy Display will double-beep and its Status LED will turn off
5) Confirm that Unlinking was successful by checking the Energy Display screen
The Energy Display screen will no longer display information for the meter device you just
Unlinked from
USING ENERGY DISPLAY
Data is retrieved when:
• Energy Display is first Linked to a meter device
• Refresh button is tapped while Energy Display is in Display Mode
• Any button is tapped in Standby Mode
Power-related information will display for one minute before Energy Display enters Standby Mode. In
Standby Mode, only the battery level and temperature will display. Tap any button to exit Standby Mode
and return to Display Mode.
Display Mode
NOTE: Green text indicates flashing text on the Energy Display screen.
Instantaneous Watts used Average cost per month Average energy used per month
Display options
Temperature
Cost setting
Meter 1
Battery level
Meter 2 Meter 3