Ken Tool 32129-98 Industrial Wheel Lock Ring Tool - Manual (Page 2)

768 E. North Street, P. O. Box 9320, Akron, Ohio 44305; Phone: 330-535-7177, Fax: 330-535-1345
www.kentool.com Contact Us: [email protected]
MOUNTING INSTRUCTIONS
2
Instruction Manual
©2007 Ken-Tool
Part No. 32129-98
1 3
6
9
2
5
8 7
4
Start one end of the split ring in
place under the wheel flange. Pull the tool toward you to hook
the MOUNT end under the ring
from the inside. The first “bite” should be a little
more than half way around from
the started end of the split ring.
Push down… …until the ring snaps into place. Lift up to release the tool.
Raise the unmounted portion of
the split ring using the
SEPARATOR end. Pull the tool toward you to hook
the MOUNT end under the ring. Push down.
Industrial Wheel Lock Ring Tool Set ™ #32129
NOTE: These tools work equally well on pneumatic tires that do not require a press or cage.