Kolpin 21540 – Ratcheting Rhino Grip User Manual

Kolpin Hardware

Advertising
background image

Rev. 1

21540 – Ratcheting Rhino Grip

No.

Description

QTY.

Spare P/N

1

Plastic Mounting Base

2

2

Metal Backer Plate

4

71513

3

Ratcheting Rhino Grip

2

4

Kwik Clip

2

6

¼” – 20 x 2.50” Truss Bolt

8

7

¼” – 20 x 1.50” Truss Bolt

8

8

¼” – 20 Nylon Nut

8

9

Rubber Strips

4

Mounting Instructions -

1. Position the Ratcheting Rhino Grip mounting base on the roll bar/rack where desired.
2. Run the ¼” bolts provided through the main plastic base, metal backer plate and then through the

metal backer plate on the back side of the rack or roll bar. Secure with nylon nut. Repeat three
more times. Rubber strips used to create friction on surface to help eliminate the possibility to
rotate on the rack/roll bar surface.

3. Tighten the (4) ¼”-20 x 2.25” (UTV) or 1.50” (ATV) truss head bolts evenly. Note: Be sure not to

over tighten the bolts, as too much torque can over stress the base and cause the grip to fail.

4. Insert the Ratcheting Rhino Grip into the mounting base and position as desired. NOTE: Grip can

rotate 360°.

5. Secure the grip to the mounting base using the plastic Kwik clip provided.
6. Repeat on opposite side of ATV or UTV.
7. Tech Tip: An occasional shot of silicone lubricant will keep grip arms moving freely!

2

3

4

Kolpin Outdoors, Inc.

205 N. Depot Street, Fox Lake, WI 53933

Phone #: (877) 9KOLPIN or (920) 928-3118

www.kolpinpowersports.com

[email protected]

These grips are designed to quickly and easily mount
to the Roll Cage of a UTV or Rack of an ATV. They fit
tubing sizes from Ø5/8” to Ø2.00”. Note: Hardware
provided is based on the biggest tube diameter. You
may need to trim the excess threads once installed.
Failure to do so may result damage to your machine.
Note: The grip can be used in the vertical and
horizontal positions.

To rotate the grip simply slide the Kwik
Clip out of the grip and rotate to the
setting of your choice, Reinsert the clip
to secure. Note: Kwik clip can only be
inserted on the push button side of the
grip.

Advertising