DoorKing 1802 Entry System - Manual (Page 30)

3.2.6 Delete All Phone Numbers
This programming step deletes all phone numbers previously programmed into the system.
CAUTION: this programming step is irreversible once it is started.
1. Press *22 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 9999 then press * (beep). This programming sequence will automatically end
itself. This will be indicated by a long tone (beeeeeep).
3.2.7 Display / Delete Phone Numbers
This program sequence is useful to display phone numbers, area codes and area code reference
numbers when you do not know what directory code they have been programmed under. This
sequence also gives you the option to delete the phone number after it is displayed.
1. Press * 25 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. The first directory code will be displayed. Press * to view the phone number, area
code reference number and area code programmed under this directory code. The
telephone number will display for 2 seconds, then the area code reference number
and area code will display for 2 seconds. This sequence will repeat itself.
3. Press * to go to the next step.
4. Press * to move forward to the next directory code, or press 0 to delete the shown
phone number and move forward to the next directory code.
5. After the last phone number is displayed and * or 0 is pressed, this programming
sequence will automatically end itself. This will be indicated by a long tone
(beeeeeep) or you can press 0#TOGETHER to end this programming step at any
time (beeeeeep).
3.2.8 Display Phone Numbers with known Directory Codes
Use this programming sequence to display phone numbers, area codes and area code reference
numbers programmed under known directory codes, i.e. if you wanted to see what is programmed
under directory code 2719 (assuming directory codes have been programmed for four digits). This
programming sequence will not allow you to delete phone numbers.
1. Press *06 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code that you wish to display the information for (1, 2, 3 or 4 digits
depending on what was programmed in 3.2.1) then press * (beep).
3. The information programmed under the directory code entered in step 2 will be
displaced on the programming display. The telephone number will display for 2
seconds, then the area code reference number and area code will display for 2
seconds. This sequence will repeat itself. If C C C C C C C is displayed, this
indicates that no phone number has been programmed under the entered directory
code. If the first digit is flashing, this is the area code reference code and indicates
that the number displayed is a long distance number.
4. To display additional phone numbers press * and repeat step 2.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 30 1802-065-E-5-10