DoorKing 1802 Entry System - Manual (Page 32)

3.3.2 Programming the Welcome Message
The welcome message, followed by the instruction message, scrolls across the screen from right to
left when the system is not in use. The welcome message can be a maximum of 48 characters
(spaces count as a character) and is entered into the system memory in three lines of 16 characters
each. The example below shows how the sample message was divided into three lines. Use the
blank matrix to organize your own message.
Default Welcome Message = WELCOME TO THE DKS PHONE SYSTEM HAVE A NICE DAY
Example WELCOME TO THE DKS PHONE SYSTEM HAVE A NICE DAY
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Line 1 W E L C O M E T O T H E D
Line 2 K S P H O N E S Y S T E M
Line 3 H A V E A N I C E D A Y
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Line 1
Line 2
Line 3
After organizing your welcome message in the matrix above, follow the instructions below to enter the
message into the system. After each desired letter, number or space is displayed on the directory,
remember to press * to enter that character. Spaces count as a character and must be entered into
memory as a character. After a complete line has been entered, press * to enter the line, then start
the next line.
1. Press *80 and enter the four-digit MASTER CODE _ _ _ _ (beep). The screen will
display: 1ST LINE WEL MSG.
2. Enter up to 16 characters in line 1. Remember to press * (beep) after each character.
3. After the last character in line 1 has been entered, press * (beep) to enter the entire line.
The screen will display: 2ND LINE WEL MSG.
4. Enter up to 16 characters in line 2. Remember to press * (beep) after each character.
5. After the last character in line 2 has been entered, press * (beep) to enter the entire line.
The screen will display: 3RD LINE WEL MSG.
6. Enter up to 16 characters in line 3. Remember to press * (beep) after each character.
7. After the last character in line 3 has been entered, press * (beep) to enter the entire line.
8. Press * to enter all three lines into the system memory.
9. The new welcome message will begin to scroll across the screen.
3.3.3 Reset Welcome Message to Default
This programming sequence allows you to reset the welcome message to the factory default.
1. Press *82 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 1* (beep) to reset the message to default, or enter 0* (beep) to keep the
current programmed message.
Page 32 1802-065-E-5-10