DoorKing 1803 Entry System - Manual (Page 38)

3.4.3 Four-Digit Entry Code Time Zone
This programming sequence sets up a time zone for the four-digit entry codes. This time zone uses a
range of four-digit entry codes and can be programmed for certain days of the week. This time zone
can be turned on and turned off after it is programmed (see operating instructions 4.2.4).
1. Press *36 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 1* (beep) to turn the time zone ON, or press 0* (beep) to turn the time zone
OFF.
3. Enter the beginning hour and minutes _ _ _ _ then press * (beep). (Four-digit entry
codes that are within the boundaries of the time zone will begin to work at this time.)
4. Press 0* (beep) for AM, or press 1* (beep) for PM.
5. Enter the ending hour and minutes _ _ _ _ then press * (beep). (Four-digit entry
codes that are within the boundaries of the time zone will cease to work at this time.)
6. Press 0* (beep) for AM, or press 1* (beep) for PM.
7. Enter the days of the week _ _ _ _ _ _ _ then press * (beep). To skip any days of the
week, enter # in place of the day. For example, to have a time zone active on
Saturday and Sunday only (Sun = 1, Sat = 7), enter 1 7 # # # # #.
8. Enter the lower four-digit boundary _ _ _ _ then press * (beep).
9. Enter the upper four-digit boundary _ _ _ _ then press * (beep).
10. Press 0# TOGETHER to end this programming step (beeeeeep).
3.4.4 Five-Digit Entry Code Time Zone
This programming sequence sets up a time zone for the five-digit entry codes. This time zone uses a
range of five-digit entry codes and can be programmed for certain days of the week. This time zone
can be turned on and turned off after it is programmed (see operating instructions 4.2.4).
1. Press *37 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 1* (beep) to turn the time zone ON, or press 0* (beep) to turn the time zone
OFF.
3. Enter the beginning hour and minutes _ _ _ _ then press * (beep). (Five-digit entry
codes that are within the boundaries of the time zone will begin to work at this time.)
4. Press 0* (beep) for AM, or press 1* (beep) for PM.
5. Enter the ending hour and minutes _ _ _ _ then press * (beep). (Five-digit entry
codes that are within the boundaries of the time zone will cease to work at this time.)
6. Press 0* (beep) for AM, or press 1* (beep) for PM.
7. Enter the days of the week _ _ _ _ _ _ _ then press * (beep). To skip any days of the
week, enter # in place of the day. For example, to have a time zone active on
Saturday and Sunday only (Sun = 1, Sat = 7), enter 1 7 # # # # #.
8. Enter the lower five-digit boundary _ _ _ _ _ then press * (beep).
9. Enter the upper five-digit boundary _ _ _ _ _ then press * (beep).
10. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 38 1800-060-R-8-11