DoorKing 1803 Entry System - Manual (Page 35)

3.3 Entry Code Programming
3.3.1 Four-Digit Entry Code Programming
This programming sequence programs four-digit entry codes into the system memory. The number of
four-digit entry codes that can be programmed is the same as the telephone number memory
capacity, plus 12. We suggest that all entry codes that are programmed into the system be listed with
the names of persons that they have been assigned to (see appendix).
1. Press *02 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the four-digit entry code _ _ _ _ then press * (beep).
3. Repeat step 2 to enter additional entry codes.
4. Press 0# TOGETHER to end this programming step (beeeeeep).
3.3.2 Delete Four-Digit Entry Codes
1. Press *14 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the four-digit entry code _ _ _ _ to be deleted and then press * (beep).
3. Repeat step 2 to delete more entry codes.
4. Press 0# TOGETHER to end this programming step (beeeeeep).
3.3.3 Delete All Four-Digit Entry Codes
This programming sequence deletes all four-digit entry codes that have been programmed
into the system. CAUTION: this programming step is irreversible once it is started.
1. Press *00 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 9999 then press * (beep). This programming sequence will automatically end
itself. This will be indicated by a long tone (beeeeeep).
3.3.4 Four-Digit Entry Code Divide Number
The four-digit entry codes can be made to activate either relay 1 or relay 2 by programming a four-
digit divide number. Four-digit entry codes equal to or less than the divide number will activate relay
1. Four-digit entry codes greater than the divide number will activate relay 2. HINT: you can make all
four-digit entry codes (except 0000) activate relay 2 by programming divide number 0000, or make all
four-digit entry codes activate relay 1 by programming divide number 9999.
The factory default divide number is 9999.
1. Press *12 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the four-digit divide number _ _ _ _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
1800-060-R-8-11 Page 35