DoorKing 1803 Entry System - Manual (Page 33)

3.2.3 Programming Area Codes
Up to 15 different area codes can be programmed for any 10-digit or long distance calling
requirements and will be referenced 01 through 15. The area codes will be entered as a four-digit
number (1 + the three digit area code). If area codes are being programmed to facilitate 10-digit
calling requirements, precede the three-digit area code with #.
1. Press *24 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter a 2-digit area code reference number _ _ (01 through 15) then press * (beep).
3. Enter the area code _ _ _ _ then press * (beep). NOTE-1: for long distance calling
requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit calling
requirements, enter # and the three-digit area code.
4. Repeat steps 2 and 3 to enter additional area codes. Remember to use a different
area code reference number when entering more area codes.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.4 Programming Phone Numbers with Area Code Reference
In this section, phone numbers that are referenced to an area code (long distance and 10-digit dialing
calls) will be programmed. Be sure that the area code(s) have been programmed as described in the
preceding section.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.2.2.
1. Press *41 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter a directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.2.1) then press * (beep).
3. Enter the 2 digit area code reference number _ _ then press * (beep).
4. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number
that you are entering in this step is less than seven-digits, enter # in the empty
spaces. For example, if the system is connected to a PBX that requires four-digit
extension numbers and you want to enter extension 2217, you would enter this
number as 2217### then press * (beep).
5. Repeat steps 2, 3, and 4 to enter additional long distance phone numbers.
6. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.5 Deleting Individual Phone Numbers
This programming sequence is used to delete a single phone number under a known directory code.
1. Press *01 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code of the phone number to be deleted (1, 2, 3 or 4 digits
depending on what was programmed in 3.2.1) then press * (beep).
3. Press # # # # # # # then press * (beep).
4. Repeat steps 2 and 3 to delete additional phone numbers.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
1800-060-R-8-11 Page 33