DoorKing 1803 Entry System - Manual (Page 34)

3.2.6 Delete All Phone Numbers
This programming step deletes all phone numbers previously programmed into the system.
CAUTION: this programming step is irreversible once it is started.
1. Press *22 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 9999 then press * (beep). This programming sequence will automatically end
itself. This will be indicated by a long tone (beeeeeep).
Sections 3,2,7 and 3.2.8 apply only to 1803 and 1810 units.
3.2.7 Display / Delete Phone Numbers
This program sequence is useful to display phone numbers when you do not know what directory
code they have been programmed under. This sequence also gives you the option to delete the
phone number after it is displayed.
1. Press * 25 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. The first directory code will be displayed. Press * to view the phone number
programmed under this directory code. If the first digit is flashing, this is the area
code reference number and indicates a long distance phone number.
3. Press * to go to the next step.
4. Press * to move forward to the next directory code, or press 0 to delete the shown
phone number and move forward to the next directory code.
5. After the last phone number is displayed and * or 0 is pressed, this programming
sequence will automatically end itself. This will be indicated by a long tone
(beeeeeep) or you can press 0#TOGETHER to end this programming step at any
time (beeeeeep).
3.2.8 Display Phone Numbers with known Directory Codes
Use this programming sequence to display phone numbers programmed under known directory
codes, i.e. if you wanted to see what phone number was programmed under directory code 2719
(assuming directory codes have been programmed for four digits). This programming sequence will
not allow you to delete phone numbers.
1. Press *06 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code of the user phone number that you wish to display (1, 2, 3 or
4 digits depending on what was programmed in 3.2.1) then press * (beep).
3. The phone number programmed under the directory code entered in step 2 will be
displaced on the programming display. If C C C C C C C is displayed, this indicates
that no phone number has been programmed under the entered directory code. If the
first digit is flashing, this is the area code reference code and indicates that the
number displayed is a long distance number.
4. To display additional phone numbers press * and repeat step 2.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 34 1800-060-R-8-11