Magnum Venus Plastech INNOVATOR PRO 5000 (8003) - Manual (Page 20)

MAGNUM VENUS PLASTECH Innovator Pro Manual 20
Locate the control circuit air pressure regulator (see figure 10) and ensure that it
is adjusted to 6 bar (0.6 MPa) (ensure the slide valve is in the “ON” position). The
gauge is marked in Mega Pascal’s (MPa), where 1MPa = 10 bar = 145PSI.
Therefore the gauge should read 0.6.
NOTE: Exceeding the upper pressure or use of lubricated air could cause
permanent damage to the controls.
NOTE: When the isolation valve (sleeve valve) is in the off position, it is
possible that residual air pressures may still remain in the system.
Overview of controls:
The Innovator Pro control panel is shown in figure 3. Controls have been
grouped based upon function, to make the system as user friendly as possible.
• Emergency Stop – Press this button in the event of an emergency to
place the system into a safe state. Twist and pull to release and allow
machine operation.
• Pump pressure
o Pressure gauge - This is the air pressure being supplied to the pump.
o Regulator – Adjust this to control the air pressure being supplied to
the pump.
• Prime – Press and hold this button to operate in prime mode.
• Start/Stop Controls
o Inject – Press to start the machine in inject mode.
o Recirculate – Press to start the machine in recirculation mode.
o Stop – Press to stop the machine in inject, recirculate or flush modes.
• Mould Pressure Guard
o Preset level gauge – Control signal air pressure being supplied to
Mould Pressure Guard (MPG) control.
o Regulator – Use this to adjust the MPG control signal air pressure.
• Stroke Count – The pre-determining counter will count on each pump
stroke when the machine is in inject. The user can enter the desired shot
count so that the machine stops automatically.
• Flush Button – Activates the flush cycle through the SP4 flush pump.