Magnum Venus Plastech INNOVATOR PRO 5000 (8003) - Manual (Page 34)

MAGNUM VENUS PLASTECH Innovator Pro Manual 34
PRE-START CHECKLIST - INNOVATOR PRO
ACTIVITIES MUST BE DONE IN THE SEQUENCE SHOWN, AND MUST BE TICKED
OFF AS COMPLETED.
ACTIVITY ACTIVITY TICK WHEN
COMPLETED
Priority Put on Respirator as specified for spray painting,
Protective Clothing, Eye Protection, and PVC Gloves
1 Have all Tools and materials available for pre-start checks.
2 Connect the 6mm air line to the to the air supply.
3 Slide the air valve on the back of the cabinet to OPEN position.
4 Twist & Pump E-Stop to allow machine operation
5 Check all catalyst & resin fitting to be sure they are tight
6 Fill resin pump packing nut 1/3 full with PAT-LS-OIL.
7 Press the Injection Button and check that the Injection Gun
valve rotates open – press the Stop button.
8 Using the “T” Bit and handle tighten the both packing nuts on
the Injection Gun block.
9 Repeat step 7 several times then repeat step 8 – do this three
time to set the packing in the gun block.
10 Press the Recirculate Button and check that the Recirculation
gun valve has rotated open – press the Stop Button
11 Using the “T” Bit and handle tighten the both packing nuts on
the Recirculation Gun block.
12 Repeat step 10 several times then repeat step 11 – do this three
time to set the packing in the recirculation gun block.
13 Fill the Catalyst Jug at least 1/2 full of catalyst.
14 Secure the Pick-up wand to the pump inlet
15 Place the Resin Pick-up wand in the resin supply container.
16 Place the end of the Resin Return Hose in the resin container.
17 Fill the Solvent Flush Tank at least 3/4 full.
18 Place the appropriate container under the Injection Head and
Test the Flush system by pressing the Flush Button.
THE UNIT IS NOW READY TO BE STARTED UP. GO TO – “FIRST TIME START-UP
INNOVATOR PRO”
ABNORMAL CONDITIONS OBSERVED AND CORRECTED
Abnormal Condition a a a a when
corrected
OPERATORS NAME _____________________________DATE: _____________