Magnum Venus Plastech UltraMAX UPLS-2300_UPLS-2300-SS - Manual (Page 39)

MAINTAINENCE AND REPAIR MANUAL
UPLS-2400-SS/2300-SS
MAGNUM VENUS PLASTECH REV 1.13
APRIL 2010 PAGE 39
OUTLET BODY ASSEMBLY
Place a liberal amount of grease inside the chevron area of all the packings. (FIG 6.1)
o Note: If the Fluid Section is to be used with a Polyester/Vinylester resin system then
a liberal coat of Red Grease should be applied to the Piston Rod Packing before
installing on to the Outlet Body. The Piston Rod Packing on an Epoxy or Urethane
system should only use approved lubricant. If in doubt contact the material
manufacturer for recommendations.
FIG 6.1
Gently slide Piston Rod assembly thru bottom of Outlet Body. (FIG 6.20)
FIG 6.20