Magnum Venus Plastech Pro Series VPRO-45220 22:1 & 7:1 - Manual (Page 16)

VPRO-45220 Series Resin Pump Manual
Rev. 11/2013 Page | 16
Lubrication:
Throughout this manual, directions are given for lubricating various parts of the Pro Pump.
There are three types of lubricant used:
 If the part contacts resin, use MVP Red Grease (6706-2-1).
 If the part is located where it will contact air, use Lubriplate ® (08465).
 Throat Seal Oil (TSL-3200) used in the oil reservoir of the pump.
DANGER: FIRE AND EXPLOSION HAZARD. Never use any lubrication on the
components of the catalyst system. Contact your catalyst manufacturer for additional
material handing information.
Major Components:
Your Pro Pump consists of the following major components:
 Resin pump Fluid section.
 Resin pump Air motor.
 Shift Block Assembly.
Description of Controls for Spray unit:
Familiarize yourself with the manifold controls, which consist of the following regulators and
gauges:
 PUMP PRESSURE gauge and regulator. These control main air pressure to the
resin pump.
 ATOMIZING-AIR gauge and regulator. This controls the air pressure to the
catalyst nozzle on the gun.
Hazard Information:
Please note the following safety and informational designations used throughout this manual:
DANGER: Indicates hazards or unsafe practices that are likely to result in severe
personal injury or death.
WARNING: Indicates hazards or unsafe practices which could result in severe personal
injury or extensive equipment damage.
CAUTION: Indicates hazards or unsafe practices which could result in minor injury or
damage to equipment.
NOTE: Indicates additional information including explanations of certain procedures or
helpful suggestions. Notes do not contain safety information.