Magnum Venus Plastech Pro Series VPRO-45220 22:1 & 7:1 - Manual (Page 23)

VPRO-45220 Series Resin Pump Manual
Rev. 11/2013 Page | 23
Pump Repair:
NOTE: Flushing the pump fluid section with solvent will make it easier to clean and
rebuild.
CAUTION: There are two (2) hard chrome balls in the Pro pump assembly. If a ball drops
to the floor, it will be damaged. (Even if it appears undamaged, it will contain dents and
scratches that will create problems.) Damaged balls must be replaced or the pump will
not work properly.
NOTE: When disassembling the Pro pump assembly, replace any O-Rings that you
expose.
Maintenance:

For a complete maintenance schedule, please refer to Chapter 3: Maintenance.
Troubleshooting:

For a complete troubleshooting schedule, please refer to Chapter 7: Troubleshooting
Chart.
Parts Drawings:

To perform service and repair on the Pro pump assembly, please follow the procedures
below. Please refer to a current parts drawing for the VPRO Pump assembly you are
working on for part numbers.
Turn Off Pressure:

Be sure all fluid pressure and air pressure is relieved from the Pro Pump assembly.
DANGER: To avoid serious injury or equipment damage, do not proceed unless the
system has been completely depressurized.
Remove Catalyst Pump:

Be sure the catalyst pump has been removed from the slave arms.