Magnum Venus Plastech SUPER PRO GUN II - Manual (Page 17)

SUPER PRO GUN &
SUPER PRO GUN II
20. Install the 5104-11-1 (Actuating Stem) into the 5104-2-1 (Valve
Rod).
21. Actuate the 5104-11-1 (Valve Stem) back and forth 3 or 4 times,
then snug both 5104-8-1 (Packing Nuts) with 9301-2-3 (Packing
Bit) until firm. Again, actuate the Valve Stem back and forth 3 or 4
times.
22. Install the 5104-32-1 (Plug), and the 7301-15-125 (O-Ring) in the
port provided on the catalyst side of the 5104-1-1 (Gun Block).
23. Install the 5104-32-1 (Plug) into the flush port on the resin side of
the 5104-1-1 (Gun Block). See Fig. 3.7
24. Install the 5104-27-1 (Catalyst Fitting), and the 7301-10-903
(O-Ring) onto the 5104-1-1 (Gun Block).
25. Install the 5104-9-1 (Resin Fitting) and the 7301-14-904 (O-Ring)
onto the 5104-1-1 (Gun Block).
26. Insert the 5104-03-01 (Injector Assembly) and 5104-17-1
(Distribution Ring) into the 5104-20-1 (Mix Housing).
NOTE
Use removable strength thread locking compound on Actuating Stem threads.
Fig. 3.7
12