Magnum Venus Plastech SUPER PRO GUN II - Manual (Page 8)

SUPER PRO GUN &
SUPER PRO GUN II
NOTE
When installing the Trigger Assembly the 5105-8-1 (Trigger Lock) must be in
the “down” position.
SUPER PRO GUN
Handle Assembly
5105-00-01
3
Chapter
2
1. Carefully install the 5105-9-1 (Trigger Nut Seal) over the
5105-10-1 (Trigger Nut).
2. Coat the 7304-4-1 (Lip Seal) with 6706-3-1 (Pro Gun Oil), and
push it into the 5105-10-1 (Trigger Nut).
3. Screw the 5105-10-1 (Trigger Nut) into the 5105-1-1 (Gun Handle),
and tighten. Coat the 5105-14-1 (Trigger Stem) with 6706-3-1 (Pro
Gun Oil) and install from the inside cavity of the 5105-1-1 (Gun
Handle) through the 5101-10-1 (Trigger Nut).
4. Place the 5105-15-01 (Pivot Plate) into the slot in the
5105-1-1 (Gun Handle Assembly), and push the 7203-4-9 (Slotted
Spring Pin) located on the back side of the 5105-16-1 (Trigger) into
the hole in the 5105-14-1 (Trigger Stem). Line up the 5105-15-2
(Pivot Plate Bushing) to the lower pivot hole in the Gun Handle,
insert the 7102-10-12 (Slotted Flat Head Screw) and tighten.
See Figs. 9.3 & 9.4 for exploded schematic drawings
NOTE
Once in place the spring of the 7304-4-1 (Lip Seal) should be facing out.