Micromod MOD: 30ML Operation and Template Setup - Manual (Page 39)

MOD 30ML Multiloop Controller
OPERATION
3-7
3.4.5 Line 6 Display
This is the 8-character display at the bottom of the front panel.
Line 6: Indicates engineering unit values for output or
set-point, as identified by [SP] or [OP] displayed
on Line 5. An engineering units label can also be
displayed. Also indicates entry point of tune
displays and displays parameter data during
tuning and template configuration.
3.5 BAR DISPLAYS
Three 50-segment bar graphs provide visual indication of process, set-point and output in the
runtime displays for a selected control loop. On the alarm displays, the left hand bar provides
visual comparison of an alarm input and its trip point for any active alarm. The other two bars
are blank on the alarm display.
Alarm trip points are indicated by intensified
segments.
Process variable on runtime display; alarm input or
set/process deviation on alarm displays.
Set-Point Variable
Output
3.6 ALARM INDICATOR
The alarm indicator is located in the upper right
hand corner of the instrument front face. This LED
indicator can be off, flashing or continuously on
depending on the instrument data base
configuration and alarm activity. A beeper can also
be configured to provide audible indication of an
alarm condition.