Minuteman E24 (7061.31) Walk-Behind Scrubber - Manual (Page 12)

12
2.7 After Work
1. Move the machine to a suitable site for
maintenance.
2. Stop machine, lift squeegee and brush
deck and remove the key.
3. Empty and clean recovery tank.
4. Check solution filter.
5. Check seals and suction hose.
6. Check operating fluid levels, function and
setting.
7.Charge batteries.
8. Clean the machine.
Empty the solution tank before shutting
down the machine for a longer time.
2.5 Operation
1. Switch on the machine.
2. Use lever (Fig. 5/3) to lower squeegee.
Vacuum motor switches on automatically.
3. Switch on solution supply by means of tip-
switch (Fig. 4/14).
4. Adjust solution amount by means of tip-
switch(Fig. 4/13).
5. Use pedal (Fig. 5/1) to lower brush deck.
Solution supply switches on automatically.
6. Use the speed control knob (Fig. 4/16b)
to adjust the work speed. Use the direc-
tion switch (Fig. 4/16a) to select forward
or reverse. Pull the bail handle (Fig. 4/16c)
to start moving.
2.6 Stop Machine
Releasing the bail handle will stop the
motion of the machine as well as the brush
head. Switch the machine off using the
key-operated switch. Protect the machine
against unintentional movements or
against being inadvertently started.
2.8 Transporting the machine
To move the machine to the place of
use, switch it on, lift the squeegee and
brush deck and pull the bail handle to
start movement.
2.9 Tie-down points
When transporting on a vehicle or trailer,
the machine has to be secured. Tie the
machine down firmly by straping it to the
front with the eye bolts (Fig. 2/1) and to
the rear with the chassis (Fig. 2/2) .
Lift brush deck before passing over
steps and other obstacles.
Observe the legal directives
and local regulations for disposal
of detergents.
Do not clean the electrical parts
using high pressure cleaning
equipment.
First Operation
Fig.2
1 2