Minuteman E24 (7061.31) Walk-Behind Scrubber - Manual (Page 39)

39
Height Adjustment
The height adjustment is set to 3 mm at
the factory. If streaks are produced,
despite an optimum angle adjustment, the
clearance between the rollers and floor
must be adjusted by changing the number
of washers on the holder.
In the case of very smooth floors, e.g.
finished floors, PVC, linoleum, etc.
Number of washers = 2. This corresponds
to a clearance of approx. 2 mm.
In the case of very uneven floors, e.g.
poorly laid tiles (water does not run off)
Number of washers = 4. This corresponds
to a clearance of approx. 4 mm.
The Squeegee is equipped with
two additional rollers which are
adjusted at the factory to a
distance of 10 mm to the floor by
means of spacers.
3 mm
2 mm 4 mm
Fig.14
Maintenance and Care