Minuteman KS 28 G (6403.xx) - Manual (Page 21)

21
Operation
Drive bar (Fig. 8/1)
The drive bar serves to activate and de-
activate the wheel drive. The drive bar
must be pulled up towards the handle-
bar with the fingers so that the wheel
drive operates and the machine moves
forward. If the drive bar is released, the
machine stops (safety circuit).
Handlebar (Fig. 8/2)
The machine is guide/steered via the
handlebar.
Release the drive bar when
turning sharp corners.
The two wing bolts (Fig. 8/4) serve to
adjust the handlebar to an optimal posi-
tion for the user.
Operating panel (Fig. 8/3)
Refer to Section 3.2.2.
Charger cable (Fig. 8/5)
The charger cable of the Minuteman
KS
28 B is located in the recess which
also contains the shaking device lever.
Shaking device lever (Fig. 8/6)
To clean the panel air filter, pull the
shaking device lever out then push
back in again; repeat this several times.
Dirt hopper lock (Fig. 8/8)
To remove the dirt hopper, move the
locking lever to the right (when facing
the front) and, at the same time pivot
the handlebar forwards. The frame of
the dirt hoppers is lowered as a result
so that the hopper can be removed to-
wards the rear. To lock the hopper, pull
the handlebar to the rear until the lock
audibly engages.