Minuteman KS 28 G (6403.xx) - Manual (Page 27)

27
Operation
3.3.6 After finishing work
1. Operate the shaking device.
2. Empty the dirt hopper.
3. Check the brush area for any residu-
al waste and remove it if necessary,
refer to Section “Cleaning the brush
space“.
4. Clean the machine, if necessary.
Warning - do not clean electri-
cal components with liquids!
Risk of electric shock!
It is not permitted to clean the
machine with a pressure wash-
er or steam blaster.
Operating the shaking device
Push and pull the lever (Fig.
8/6) in and
out several times in succession to clean
dust from the panel air filter.
Only operate the shaking de-
vice when the engine is
switched off.
Emptying the dirt hopper
1. Move the locking lever (Fig.
8/8) to
the right (looking to the front) and, at
the same time, tip the handlebar
(Fig.
8/2) to the front.
2. Remove the dirt hopper (Fig. 12/2)
from the machine and empty it.
Carry the dirt hopper
(Fig.
12/2) by the handles
(Fig. 12/1).
Fig. 12
Observe the applicable laws
and local regulations when dis-
posing of waste.
3.3.7 Loading and transportation
When loading the machine and
transporting it to its area of de-
ployment, the side brush must
be raised.
Loading
When loading the machine, take its
weight into account, refer to Section
‘‘Technical Data‘‘.
Transporting
The machine must be properly
secured. It must not slip or tip
during transportation! Risk of
injury!
When transporting on a vehicle or trail-
er, the machine must be secured
against rolling away: Lash down the
machine securely at the front and rear.
2 1