Minuteman KS 28 G (6403.xx) - Manual (Page 28)

28
Operation
• Secure the machine at the front with
a strap which must be fed through
the two openings (Fig.
13/1) near the
front wheel (Fig. 13/2).
• At the rear, thread a strap around the
bottom ends of the handlebar and fix
the strap to the transporter.
Fig. 13
3.4 Function faults
• If the machine is overloaded, the en-
gine speed drops.
Set the key switch to Position 0.
Check the side brush, rotary brush
and brush area for residual waste
and remove the waste, if necessary.
Ensure that there is sufficient fuel in
the tank (only Minuteman KS
28 G)
or that the battery is sufficiently
charged (only Minuteman KS
28 B).
Start the machine. If the fault occurs
again, contact a Minuteman service
center.
If the machine cannot be
switched off, pay attention to
the rotating fan when you dis-
connect the cable or pull out
the spark plug connector! Risk
of injury!
3.5 Options
The basic machine can be upgraded by
adding further components. The order
and spare parts numbers for these
components are provided in brackets.
• Carpet kit (6460)
By fitting the carpet kit on the Minu-
teman KS
28 B, the machine is con-
verted for clearing up dry waste from
carpets.
Please refer to the spare parts
catalogue on our internet site
at http://ezparts.sysonline.com
/minuteman for accessories,
such as rotary brushes, side
brushes etc.
2
1 1